Leaderboard

Have my BRZ and WRX currently... the V7 is not mine....unfortunately

After noticing some dead spots in the low beam lights on Mum's Outback, I was pretty keen to figure out what the hell was causing it These are the bi-xenon HID projectors on a NZ New 08 Outback. Made a decent pattern on the beam-setter, but couldn't quite understand the patchy output. I pulled the bumper and grille off to remove the lights. Bulbs appeared fine if a little aged. Next, I pulled out the reflector bowl/bulb housing behind the projector lens, and found the reflective chrome had started to peel off the housing. Next step is finding someone who can re-paint these, or if they need vacuum metalizing or what...

I'd probably get DBA rotors instead. Those thickened shoes are not cheap at all and could only find them in the UK. Was a few years ago though so might've changed now

I have (had) the same issue with my lights, water was getting in some how and fogging. To the point where it failed a wof. I've taken them off, cleaned, checked for cracks ect, can't find anything. All i did was drill two small holes at the lowest two points for any water to drain out/get air circulation. Been that way for a few years now, no issues at all