Tl:dr - Can I swap an EJ205 from a V6 WRX into a V3 WRX STi without mods?
As older members may remember my V3 WRX STi (GC8D) appears pretty buttercup coloured and leaves a citrus aftertaste. Well the grapefruit, It's blown another engine.
I have acquired an EJ205 from a V6 WRX (GF8G) and am wondering if I can just bolt it in plug it up and bomb off into the sunset without any major issues or funny business required to get it going?
The EJ205 is only supposed to be a stop gap measure until I can get round to stripping down and rebuilding the EJ20K. It has taken me 2 years to get the new motor and now another 6 months to think about working on the car so this may take a while.
Any advice and suggestions would be greatly appreciated.