Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

Bp how to remove whole rear fog/reverse light assembly


Jccmuir

Recommended Posts

Howdy folks, i need to repaint the whole piece of trim on the rear hatch of '08 gtb facelift. The piece that houses the reverse and fog lights, badge etc but cannot figure out what im missing, have the interior of the hatch off and found the obvious two 10mm nuts to remove but otherwise i see nothing. Any help would be greatly appreciated! 

Link to comment
Share on other sites

22 hours ago, Jccmuir said:

obvious two 10mm nuts to remove

 

If I remember correctly from when I removed mine over 3 years ago, there are more like 6-8 nuts which need to come off to allow the garnish to be removed... All symmetrical of course (either side of the badge), the final on is located very close to the outer edge of the garnish and is what caught me up for a while because it isn't easily visible.

 

What ever you do, do not pull on the plastic if it doesn't want to move otherwise you will crack the garnish, you likely still have a nut to remove and it will easily pull away from the hatch once they've all been taken care of. Good luck dude.

Link to comment
Share on other sites

On mine, it was obvious, but I missed the bolt that is behind the badge on the back , I though maybe that just slid on to a stud.. but no theres a bolt.  I never managed to get the hand pull bit off the right hand side so I could fully remove the plastic but it was enough to install my reversing camera where the number plate light is

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Recent Status Updates

    • MrSg9Sti04

      Afternoon team,
      im new to the group first time posting. Im hoping some body can help me get my launch control all dialled in on my link g4x. Ive had the computer and car all tuned from chris at prestige awesome knowlegable guy super happy with the results but now im wanting to get my launch/anti lag all dialled in. Ive been reading multiple different forums etc all with different conflicking information which has made me nervious with what do i listen to this or that if you get what i mean. Now ive started to make myself familiar with my PClink software etc the past few weeks and im eager to learn how to do minor setups or tweaks etc so im not relieing on my tuner so much and obviously saving myself abit hurt in the back pocket. 
      Now back to the question at hand.... Im wondering if theres and one who could please share there knowledge and wisdom with setting all my values, timing, fuel etc when i have launch control armed and engaged, or even a launch tune file they can possibly send me to load onto my tune. Ive figured out the setup of my digital inputs turning launch control on etc and its obvisously on its pre set factory settings. It engages but doesnt sound the greatest or as angry as it should i feel. Hence reaching out to you good buggers. 
       
      Cheers in advance for any info and help yous maybe able to give me.
       
      Cheers Shaun
      · 0 replies
    • Joker  »  gotasuby

      updated your DP's too : hope that's ok!
      · 0 replies
    • Joker  »  SAS

      Updated your DP's to reflect your business page  
      · 0 replies
    • Joker  »  Nachoooo

      Updated your Avatar : couldnt help myself  cheers!
      · 0 replies
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    40.9k
    Total Topics
    573.5k
    Total Posts


×
×
  • Create New...