Jump to content
Please check your junk folder for registration emails ×

Leaderboard

Popular Content

Showing content with the highest reputation on 10/08/20 in all areas

  1. Soooo did a thing again. Sold my RS4, and thought I'd try find a cheap but well modded car to drive until the V11 gets finished. Enter the 2002 Prodrive STI. All the right bolt ons including a link ECU, TE37s, semi slicks, new Teins and making 220kw! Only catch is high 220kms. Looks to be well maintained mechanically though! Body requires a bit of TLC. All in all, great car! Building up my photography skills too haha.
    3 points
  2. the other forum I am on recommends Kilmat highly (bout half price of Dynamat or other alternatives have asked their thoughts on this product you've suggested
    2 points
  3. @Niran Is just about the biggest car whorree around I reckon 😂
    2 points
  4. very lightweight and waterproof. not sure I buy the fireproof but looks to self extinguish so that is good. https://www.trademe.co.nz/motors/car-stereos/other/listing-2732507824.htm?rsqid=e9f13944b2fa48bbaae154fbe4324020-002
    1 point
  5. For the Win 101 - come to me for driving lessons
    1 point
  6. What machine of the heads are you referring too? looks like you need the pistons machined to have valve pockets for clearance. generally you want a gap of 1-2mm around and under the valve face to get good flow and allow for any thermal expansion. where about are you located?
    1 point
  7. Lol plate For The Wealth 101 so you’re at the uni entry level.
    1 point
  8. Added 2 sheets of quilted sound deadening to the front foot wells. only needed two holes for the clips and it slide in as it’s exactly 50cm wide the same as the floor. i forgot what a complete nightmare lifting the carpet is in these newer cars. the sills are attached to the carpet with staples and those plastic cable carriers are under the belt lower mount etc. So I left it all in there other than pulling off the little domes that hold the carpet to the firewall and Center console and slide it into place. Took about 15 mins for both sides... then found out there is massive gaps with no foam or sound deadening right under the front edge of the front seats between the heater vents for the rear seats. You can see straight to the metal... if the front seems like it works OK I’ll order a couple more sheets for the rear.
    1 point
  9. So 4yrs 1month later, I've wrapped this mofo up. Put everything back together today, and she runs as smooth as silk. Starts after a couple of cranks, power comes on early and smooth, VOD is manageable, and no more hissy sucky intake noise. Hit me up for any details if you're planning on doing the intake pipe fix.
    1 point
  10. Rust in the floor of the RA so looks like my cert is gonna be a *tad* more expense then I had hoped🙃
    0 points


×
×
  • Create New...