Grey Haired

Can you assist with E-Manage Ultimate info? Or not your thing?

Thanks

Is it possible to fit pink injectors into a V3 manifold and rails or are they totaly different?

No fluid leakage that we can see. I will bleed again this weekend

Reasonable beating. Will check mounts this weekend. Notice clutch pedal disenagement height increases with time when I drive. ie lots of movement when cold and then creeps to the top, strange. Any ideas?

Got a mechanic to install, so would say yes to clean and mount being good. Was no worry with old 5 speed box and clutch

Around 180km shudder from the start. Is organic material

Just replaced my six speed clutch plate, pressure plate and also had flywheel resufaced. The plate is an organic and the clutch is a heavy duty one. The clutch shudders badly on take off. Its OK up the gears and down right bad on change down unless I give the throttle a blip. The whole car shakes real bad Anyone experienced this before? I have read on internet that they can be an issue. Any solutions please

Do bug eye 2002 wheel fit a V3 1997 WRX without hassles? They are 17inch with 215 45 tyres

Marc txt me 0211903833 flywheel etc

Is a five speed starter motor the same as a six speed one? :-\ If not what the difference?

Just thinking bigger motor (2.5) MORE POWER. Had been told by someone put a fuel reg on turn up the pressure and the EJ257 would run OK.

No just thinking I might as I have a V3 and want a later motor but don\'t really want to change everything. So was thinking of using the V3 control gear and heads.

Is it practicable to run V3 ECU STI 6S with a EJ257 motor and V3 STI heads? (or even possible?)

Thanks Guys

ANd just to be clear, beat option is to use 6 speed flywheel, clutch and starter motor but its possible to use 5 speed?

3.9 STI RA Plate diff the one Speedfreak is offering in this thread?

Thanks guys What about axles?

THanks will keep in mind

When fitting a V7 6 speed gearbox to a V3 how do you get the speedo to work? I understand that I need diff to match, front axles, but not rear? Also do I need clutch to suit ? What about stater motor? Slave nad master cylinder Anything else?

Is it possible to put V3 heads on a 2.5lt block or does it mess the compression ratio up or any thing else?