Jump to content
Please check your junk folder for registration emails ×

Search the Community

Showing results for tags ' skids'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • General
    • General Vehicle Discussion
    • Stolen Vehicle Register
  • Knowledge Base
    • General FAQ (Read Only)
    • Model Specific Discussion
    • Non Model Specific Discussion
    • Legal
    • Motorsports
    • "Other" Tech Questions
    • Product and service reviews
  • Regions/Events
    • ClubSUB Events
    • Auckland/Northland
    • Waikato / Bay of Plenty / Taupo
    • Taranaki / Whanganui
    • Manawatu / Wairarapa / Hawkes Bay
    • Wellington / Kapiti
    • Nelson Bays/Marlborough
    • Canterbury
    • Otago / Southland
    • Outside NZ
  • Classifieds
    • Car Exchange
    • Parts Exchange
  • ClubSUB Shop
    • ClubSUB Shop

Product Groups

  • Subscriptions
  • CS Clothing
  • Stickers and Decals
  • Subaru Branded items
  • ClubSUB branded items
  • Limited Edition Items

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


About Me


Drives :


Interests


Location


Occupation

Found 1 result

  1. Firstly this is a how to dealing with welding a centre diff BUT allowing the retaining of the front axles so to make it easier to pass a WOF without to many questions. Now for the warnings I take no responsibility about any damage done to the vehicle or person whom under takes this mod . You will need to take the centre diff out of the gearbox, this can be done with gearbox in car This is the centre diff as it should look (this one is from a 93ish GT so yours may look different) Dismantle the centre diff by removing the circlip I would also remove all bearings if u wish to reuse them, You should now have 3 bits the carrier, the drive flange and the viscous coupling, u will need to cut part of the viscous coupling of to negate the front drive After some measurements I figured out that a length of 20mm would work best Marked Cut The 2 parts now, a wee clean up and looks good I used a 4" grinder with a 1mm cutting disk on it,I would suggest having it parted of in a lathe but mine is only a wee hobby lathe All back together and welded at the spider gears Put back in and go do a some skids
×
×
  • Create New...