Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

OLD Dyno Leaderboard Top Twenty


Guest

Recommended Posts

  • Replies 339
  • Created
  • Last Reply

Top Posters In This Topic

Top 20 dyno board.... Umm suggestion to consider

Can the fuel used be stated with all top 20 ?

Pump gas , C16 , methanol etc

Also if road legal or not and state what the use is , ie drag / circuit

Link to comment
Share on other sites

 nt_a_foz']

[quote name='xecuta said:

Thanks I wonder what I get at 22psi ?

/quote]

Be suprised if they can push it to 22psi man the turbo will run out of puff by then id say.

Mine was pretty much topped at peaking 20 odd psi.

Same here. peaks at about 21-22psi at low revs and comes back to about 20psi fairly quickly and holds right though at 20.

Link to comment
Share on other sites

that isnt too bad though... thats just 2psi drop... what ever it is, is better then 15.6psi. VF37 is tempery at the moment til the IHI RX6 is getting rebuild

car is getting retune tomorrow with the new MAF pipe being machined out from 65mm to 72mm. the AFM is also been replaced same as new iridium plugs... was going to use platniums but im alway been happy with iridiums

Link to comment
Share on other sites

 xecuta said:

that isnt too bad though... thats just 2psi drop... what ever it is, is better then 15.6psi. VF37 is tempery at the moment til the IHI RX6 is getting rebuild

car is getting retune tomorrow with the new MAF pipe being machined out from 65mm to 72mm. the AFM is also been replaced same as new iridium plugs... was going to use platniums but im alway been happy with iridiums

Ive heard iridiums are better than platinums anyway? I could be wrong though

Link to comment
Share on other sites

  • 3 weeks later...

chucked car on dynopowers dyno other day bit over 190kw at 6000rpm on 12psi air/fuel went all over place after 6g any advise got bosch 044 surgetank etc. relatively standard dsr turbo extractors full 3"stainless exhaust hdi boost controller. getting link storm in nxt couple weeks will this stop problem? wit put slip up soon

Link to comment
Share on other sites

 maserati mick said:

190kw @ 6k with 12psi thats exactly What im after what engine model and ecu

v4 sti as far as I know don't know what computer is in it haven't checked will be ditched for link shortly bring on 200kw+

Link to comment
Share on other sites

 rskikn said:

Make :subaru

Model :legacy RS

Year:1989

Name of Dyno :speedsource

Date of run 01/06/2011

299kw@25psi on 95oct no nos no race gas.. standard gtb heads.. gt3082r garrett..

good effort, nice to see a BC5 doing well :)

Link to comment
Share on other sites

 rskikn said:

Make :subaru

Model :legacy RS

Year:1989

Name of Dyno :speedsource

Date of run 01/06/2011

299kw@25psi on 95oct no nos no race gas.. standard gtb heads.. gt3082r garrett..

dyno plot?

gtb heads as in bg5(pre 98) or bh5?

Link to comment
Share on other sites

 pl0x']

[quote name='rskikn said:

Make :subaru

Model :legacy RS

Year:1989

Name of Dyno :speedsource

Date of run 01/06/2011

299kw@25psi on 95oct no nos no race gas.. standard gtb heads.. gt3082r garrett..

/quote]

dyno plot?

gtb heads as in bg5(pre 98) or bh5?

theres a pic of it in the what have you done to your car today thread... sum where... lol... 96 gtb.. dont have a scaner..

Link to comment
Share on other sites

Make :subaru

Model :legacy B4

Year:2000

Turbo: MSE TD06/05 20G

Fuel: BP98

Engine: V4 STi fitted with Kelford cams

Name of Dyno : NZEFi

Date of run 21/07/2011

Power:231.4 @ 19psi

Torque: 360.6 Nm

Will update with dyno sheet once I get my hands on a scanner

Watch this space, will return with even MOAAARRR POWWAAAARR haha (but not anytime soon)

Link to comment
Share on other sites

 B4 2000 said:

Make :subaru

Model :legacy B4

Year:2000

Turbo: MSE TD06/05 20G

Fuel: BP98

Engine: V4 STi fitted with Kelford cams

Name of Dyno : NZEFi

Date of run 21/07/2011

Power:231.4 @ 19psi

Torque: 360.6 Nm

Will update with dyno sheet once I get my hands on a scanner

Watch this space, will return with even MOAAARRR POWWAAAARR haha (but not anytime soon)

Woah that's nice! Your car must be quite quick hahha. Loving it! B4 all the way hhaha.

Link to comment
Share on other sites

 B4 2000 said:

Make :subaru

Model :legacy B4

Year:2000

Turbo: MSE TD06/05 20G

Fuel: BP98

Engine: V4 STi fitted with Kelford cams

Name of Dyno : NZEFi

Date of run 21/07/2011

Power:231.4 @ 19psi

Torque: 360.6 Nm

Will update with dyno sheet once I get my hands on a scanner

Watch this space, will return with even MOAAARRR POWWAAAARR haha (but not anytime soon)

dam that elmo chick is distracting!!! takes me ages to read anything you post hahahahahahaha

Link to comment
Share on other sites

 BF5GT90']

[quote name='rskikn said:

Make :subaru

Model :legacy RS

Year:1989

Name of Dyno :speedsource

Date of run 01/06/2011

299kw@25psi on 95oct no nos no race gas.. standard gtb heads.. gt3082r garrett..

/quote]

good effort, nice to see a BC5 doing well :)

hmmmm... good effort... wtf?? lol 299kw@ all 4 in a dayly driver.. lol :o

Link to comment
Share on other sites

 kwi_fozze']

[quote name='rskikn said:

dam that elmo chick is distracting!!! takes me ages to read anything you post hahahahahahaha

/quote]

+1

You click on his name above it, then on the image, right click and press view image.

;)

Link to comment
Share on other sites

 Lampard']

[quote name='rskikn said:

dam that elmo chick is distracting!!! takes me ages to read anything you post hahahahahahaha

/quote]

+1

You click on his name above it, then on the image, right click and press view image.

;)

sweet.. its now my csreen saver lol :P

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recent Status Updates

    • MrSg9Sti04

      Afternoon team,
      im new to the group first time posting. Im hoping some body can help me get my launch control all dialled in on my link g4x. Ive had the computer and car all tuned from chris at prestige awesome knowlegable guy super happy with the results but now im wanting to get my launch/anti lag all dialled in. Ive been reading multiple different forums etc all with different conflicking information which has made me nervious with what do i listen to this or that if you get what i mean. Now ive started to make myself familiar with my PClink software etc the past few weeks and im eager to learn how to do minor setups or tweaks etc so im not relieing on my tuner so much and obviously saving myself abit hurt in the back pocket. 
      Now back to the question at hand.... Im wondering if theres and one who could please share there knowledge and wisdom with setting all my values, timing, fuel etc when i have launch control armed and engaged, or even a launch tune file they can possibly send me to load onto my tune. Ive figured out the setup of my digital inputs turning launch control on etc and its obvisously on its pre set factory settings. It engages but doesnt sound the greatest or as angry as it should i feel. Hence reaching out to you good buggers. 
       
      Cheers in advance for any info and help yous maybe able to give me.
       
      Cheers Shaun
      · 0 replies
    • Joker  »  gotasuby

      updated your DP's too : hope that's ok!
      · 0 replies
    • Joker  »  SAS

      Updated your DP's to reflect your business page  
      · 0 replies
    • Joker  »  Nachoooo

      Updated your Avatar : couldnt help myself  cheers!
      · 0 replies
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    40.9k
    Total Topics
    573.5k
    Total Posts



×
×
  • Create New...