Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

What rubber and Wheel dimensions does everyone run?


Recommended Posts

Car: 2001 BH GTB

Suspension: Cusco coilovers set somewhere between stock height and all of the lowering spring/Bilstein combos I've seen on other Leggys.

Mags: Factory E-Tune 17's (gosh they're light!)

wheels diamater: 17

Wheels width: 215

Offset: ?

Tyres spec: Dunlop Direzza's

Did you have to roll the guards?: Nope!

Link to comment
Share on other sites

Car: 98 ver5 WRX

Suspension: Teins Adjusties

Mags: DTM demons

wheels diamater: 18

Wheels width: 8"

Offset: ?

Tyres spec: 215/35/18

did you have to roll the gaurds?: yes very much so when i had the old 235/50/18 tires but much better now there low profile.

Adjustables for the win.

Link to comment
Share on other sites

Car: wrx V1

Suspension:Supa Lows

Mags:Very plain Advantis

wheels diamater:17''

Wheels width:7.5

Offset:unsure

Tyres spec:215 40 (or45)/17 (i recon too big)

did you have to roll the gaurds?:Not yet... but rubs with full carload full tank and full boot...if empty never rubs

Link to comment
Share on other sites

Car: 1996 BG5 GTB (white of course)

Suspension: Vogtland Springs (40mm drop)

Mags: Subaru Factory 5 spoke

Wheels diameter: 17"

Wheels width: 7"

Offset: Standard

Tyres spec: 215 / 40 / 17 Kingstar somethings... (chinese rubbish)

Did you have to roll the gaurds?: Nope...

Link to comment
Share on other sites

Car:'99 V5 Wrx

Suspension: Tein Adjusties

Mags: V7 Standard

wheels diamater: 16"

Wheels width: 215

Offset: ?

Tyres spec: DZ101's

did you have to roll the gaurds?: Negatory

Lightweight and no effect on insurance as not aftermarket.

Link to comment
Share on other sites

  • 2 weeks later...

Car: 1999 BH GTB

Suspension: Adjustables

Mags: Advanti Nitros

wheels diamater: 18"

Wheels width: 7.5"

Offset: pass

Tyres spec: 215/35/18 (I want more sidewall though)

Did you have to roll the gaurds?: Nope

Clear Brembos ;D

Link to comment
Share on other sites

  • 1 month later...

Car: Ver 3 Sti RA

Suspension: Ksport Coilovers with King 180mm race coils

Mags: Rota Slipstream

wheels diamater: 17"

Wheels width: 8"

Offset: +48

Tyre spec: 225/45/17 Dunlop 03G Semi slicks

Did you have to roll the guards?: Rears only, might need to just do the front a little

Link to comment
Share on other sites

  • 3 weeks later...

Car: 1998 BD5C RSB

Suspension: Stock Bilsteins/Stock springs

Mags: ROH Adrenaline in shadow chrome

Wheels diamater: 17"

Wheels width: Pass

Offset: Pass

Tyres spec: 215/45/R17 Toyo Proxes4

Did you have to roll the guards?: No

Link to comment
Share on other sites

  • 3 weeks later...

Car: 2000 Forester

Suspension: Tein springs

Mags:unknowns

wheels diamater: 18"

Wheels width: Pass

Offset: Pass

Tyres spec: 235/40R18 - Gislaved Speed 506

did you have to roll the gaurds?: nope

Link to comment
Share on other sites

  • 2 months later...

Car: V6 WRX Sti Hatch

Suspension: Standard

Mags: B4 Rims

wheels diamater: 17"

Wheels width: 7"

Offset: Unsure

Tyres spec: Bridgestone Adrenalin 215/40r17

did you have to roll the gaurds?: No

Link to comment
Share on other sites

  • 3 weeks later...
Guest TwinTubroImpreza

Car: 1998 Subaru Impreza

Suspension: Tien Lowering Springs with Monroe Shocks

Mags: 17x7" 5 stud aftermarket

Wheels diameter: 215/45r17 Dunlop directional

Did you have to roll the guards?: Going to roll the rear guards when I get aftermarket camber kits installed. Front guards are sweet as

Link to comment
Share on other sites

Car: Subaru Impreza Sti Type R V4

Suspension: Had factory shocks and tein lowered springs NOW adjustables

Mags: Works Emotion CR Kai

Wheels diamater: 17 inch

Wheels width: 7.5"

Offset: ?

Tyres spec: Back: 215/45/17

Did you have to roll the guards?: Only rears with factory suspension now adjustys had to roll fronts now and remove plastic.

Link to comment
Share on other sites

  • 4 weeks later...
  • 2 weeks later...

Car: '99 STi RA

Suspension: Coilovers

Mags: Enkei RPF1

Wheels diameter: 17"

Wheels width: 8"

Offset: +45

Tyres spec: 235/40 (Run wide as most 245's though)

Did you have to roll the guards?: No, with the dampers set stiff/Yes, when they are setup soft

I also think you should add alignment to the form, it plays a huge part in what will fit and what won't.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recent Status Updates

    • MrSg9Sti04

      Afternoon team,
      im new to the group first time posting. Im hoping some body can help me get my launch control all dialled in on my link g4x. Ive had the computer and car all tuned from chris at prestige awesome knowlegable guy super happy with the results but now im wanting to get my launch/anti lag all dialled in. Ive been reading multiple different forums etc all with different conflicking information which has made me nervious with what do i listen to this or that if you get what i mean. Now ive started to make myself familiar with my PClink software etc the past few weeks and im eager to learn how to do minor setups or tweaks etc so im not relieing on my tuner so much and obviously saving myself abit hurt in the back pocket. 
      Now back to the question at hand.... Im wondering if theres and one who could please share there knowledge and wisdom with setting all my values, timing, fuel etc when i have launch control armed and engaged, or even a launch tune file they can possibly send me to load onto my tune. Ive figured out the setup of my digital inputs turning launch control on etc and its obvisously on its pre set factory settings. It engages but doesnt sound the greatest or as angry as it should i feel. Hence reaching out to you good buggers. 
       
      Cheers in advance for any info and help yous maybe able to give me.
       
      Cheers Shaun
      · 0 replies
    • Joker  »  gotasuby

      updated your DP's too : hope that's ok!
      · 0 replies
    • Joker  »  SAS

      Updated your DP's to reflect your business page  
      · 0 replies
    • Joker  »  Nachoooo

      Updated your Avatar : couldnt help myself  cheers!
      · 0 replies
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    40.9k
    Total Topics
    573.5k
    Total Posts
×
×
  • Create New...