Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

Dyno Leaderboard Version III


Recommended Posts

 rex-leggy said:

Why wont a 2.5 rev till 9? I never said a smaller housing just change for a twin scroll.

My mazda lantis could make 300kw with tuning so whats a chev got to do with anything :D

I want to see that happen, would be pretty entertaining

Link to comment
Share on other sites

  • Replies 448
  • Created
  • Last Reply

Top Posters In This Topic

 lachlan']

[quote name='rex-leggy said:

Is it a 2.5 yea? Thats a good delivery from a big turbo.

Twin scroll?

/quote]

No to both single scroll turbo, didn\'t want to go to 2.5 otherwise I won\'t be able to rev to 9k but we went big on everything cams valves etc etc

Dude twinscroll and 2.5 would really benifit you. You would get peak power almost 2k earler

once it revs to 9 it will have a 4.5k rpm wide seroiusly powerfull powerband

hosres for courses . earlier power is irrelevant if it revs to 9 . still has awesome area under the graph . doesnt matter how far up or down the graph the area is

its like the modern ktm 350cc motox bike . it is competitive against 450cc bikes although it has less peak power and makes it higher in the rev range it has a better area under the graph

are you going to use the nos in a similar fashion to the gob stopper wrx ?

http://www.rogerclarkmotorsport.co.uk/images/gobstopper/gobstopper_power_graph.png

thats a very old dyno sheet from gobstopper not sure if they still run like that, hes added alot of nos 90kw shot i mite not want to go that far last time we ran a 60kw shot and that felt good + i need to get the full potential out of the motor before the nos.

i was surprised to see gobstoppers sheet lol i over layed mine on top and hes low on torque by around 200nm

Link to comment
Share on other sites

 marc said:

it is a drag car ;D so bring on some decent axles and the strip ;D

I still don\'t have the billet axles we ordered so will be running factory for now, any one got spear r180 axles is more then welcome to donate or sell here. trying to get my hands on a few

Link to comment
Share on other sites

just lacking a bit of response down low, thought I wanted a car with heaps of power and didn\'t care and response but after driving it for 7-8 months as a daily, decided I wanted more response. If I had twin scroll and AVCS it would have been perfect I think. my old dyno pulls are on the same plot, you can see the red and green lines are the new setup

So my advise for people building cars and trying new setup is take someone elses for a drive first, make sure you know what your after. 220kw is still not a slow car by any means

haven\'t driven it far yet but definately comes on boost earlier, now its track time ;D

Link to comment
Share on other sites

 R8TD_R']

[quote name='rex-leggy said:

Is it a 2.5 yea? Thats a good delivery from a big turbo.

Twin scroll?

/quote]

No to both single scroll turbo, didn\'t want to go to 2.5 otherwise I won\'t be ablie to rev to 9k but we went big on everything cams valves etc etc

Dude twinscroll and 2.5 would really benifit you. You would get peak power almost 2k earler

once it revs to 9 it will have a 4.5k rpm wide seroiusly powerfull powerband

hosres for courses . earlier power is irrelevant if it revs to 9 . still has awesome area under the graph . doesnt matter how far up or down the graph the area is

its like the modern ktm 350cc motox bike . it is competitive against 450cc bikes although it has less peak power and makes it higher in the rev range it has a better area under the graph

are you going to use the nos in a similar fashion to the gob stopper wrx ?

http://www.rogerclarkmotorsport.co.uk/images/gobstopper/gobstopper_power_graph.png

thats a very old dyno sheet from gobstopper not sure if they still run like that, hes added alot of nos 90kw shot i mite not want to go that far last time we ran a 60kw shot and that felt good + i need to get the full potential out of the motor before the nos.

i was surprised to see gobstoppers sheet lol i over layed mine on top and hes low on torque by around 200nm

Haha no disrespct rex leggy but its like u tryna tell a god what to do.i kno rated r and hes had more cars and different setups iv ever seen possible.haha

Link to comment
Share on other sites

 ra555']

[quote name='rex-leggy said:

Is it a 2.5 yea? Thats a good delivery from a big turbo.

Twin scroll?

/quote]

No to both single scroll turbo, didn\'t want to go to 2.5 otherwise I won\'t be ablie to rev to 9k but we went big on everything cams valves etc etc

Dude twinscroll and 2.5 would really benifit you. You would get peak power almost 2k earler

once it revs to 9 it will have a 4.5k rpm wide seroiusly powerfull powerband

hosres for courses . earlier power is irrelevant if it revs to 9 . still has awesome area under the graph . doesnt matter how far up or down the graph the area is

its like the modern ktm 350cc motox bike . it is competitive against 450cc bikes although it has less peak power and makes it higher in the rev range it has a better area under the graph

are you going to use the nos in a similar fashion to the gob stopper wrx ?

http://www.rogerclarkmotorsport.co.uk/images/gobstopper/gobstopper_power_graph.png

thats a very old dyno sheet from gobstopper not sure if they still run like that, hes added alot of nos 90kw shot i mite not want to go that far last time we ran a 60kw shot and that felt good + i need to get the full potential out of the motor before the nos.

i was surprised to see gobstoppers sheet lol i over layed mine on top and hes low on torque by around 200nm

Haha no disrespct rex leggy but its like u tryna tell a god what to do.i kno rated r and hes had more cars and different setups iv ever seen possible.haha

no disrespect taken . dont take any when I say your a douchbag :D

god wtf. im just sain that twinscroll would do wonders for his lag.

he can do what he likes dosent bother me at all

Link to comment
Share on other sites

Haha some people on clubsub are always serious people and haters.haha funny as an that why I come on here . Its crak up. All im saying is that ratd r is a well respected car and you tryna tell him whats best for his car.haha I think hed kno. It oviously shows 10.03.

Link to comment
Share on other sites

  • RAYDEO unpinned this topic

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recent Status Updates

    • MrSg9Sti04

      Afternoon team,
      im new to the group first time posting. Im hoping some body can help me get my launch control all dialled in on my link g4x. Ive had the computer and car all tuned from chris at prestige awesome knowlegable guy super happy with the results but now im wanting to get my launch/anti lag all dialled in. Ive been reading multiple different forums etc all with different conflicking information which has made me nervious with what do i listen to this or that if you get what i mean. Now ive started to make myself familiar with my PClink software etc the past few weeks and im eager to learn how to do minor setups or tweaks etc so im not relieing on my tuner so much and obviously saving myself abit hurt in the back pocket. 
      Now back to the question at hand.... Im wondering if theres and one who could please share there knowledge and wisdom with setting all my values, timing, fuel etc when i have launch control armed and engaged, or even a launch tune file they can possibly send me to load onto my tune. Ive figured out the setup of my digital inputs turning launch control on etc and its obvisously on its pre set factory settings. It engages but doesnt sound the greatest or as angry as it should i feel. Hence reaching out to you good buggers. 
       
      Cheers in advance for any info and help yous maybe able to give me.
       
      Cheers Shaun
      · 0 replies
    • Joker  »  gotasuby

      updated your DP's too : hope that's ok!
      · 0 replies
    • Joker  »  SAS

      Updated your DP's to reflect your business page  
      · 0 replies
    • Joker  »  Nachoooo

      Updated your Avatar : couldnt help myself  cheers!
      · 0 replies
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    40.9k
    Total Topics
    573.5k
    Total Posts



×
×
  • Create New...