Hey my speedo is out in one of my vehicles.
current tyre size 205/70/R14 94H
10kms out at 100km.
Wondering what tyre size id need to fix this if im switching to 18\'s
hoping 225/35/R18 will work
Looking at a Hiace but just wondering how I could mount the factory rails to V4 WRX seat (or any bucket seats)
Reason is certs are pretty pricy since i have to drive 2hrs each way to get one - fuel ect
Wanting to replace the 3 front seats with 2 Buckets
Sorry for a non subi post but the toyota forum kinda sucks -- still have my B4, but swaped our WRX for a Hiace (fits drift trike better )
I just think it really weird that my V4 wrx was dead easy and loud to install. Yet B4 easy but quiet? I know they\'re different engines, years, intercoolers ect. But it should still sound the same even tho the B4 runs 3psi more
Yea sorry i have a B4 rev C. With a bolt on GFB with every hose that the original hose had in the right places. All i did was fit the vac on. And recirc hose back on to bov. Bolt to intercooler?
Same hoses, used new hose clamps, used new gasket ect.
Its a $380 GFB from a sponsor from here il keep it on as its a bit just to chuck away. It just doesn\'t even sounds like a bov on vent. Ive tried a cheap trumpet same thing no noise. Ive defo got boot goes amazingly ect. You can hear a tiny recurk on 100% recurc. For running 14psi and I\'ve herd other b4\'s and they\'re pretty loud. I just don\'t understand i get what sounds like a wimpy fart that you can bearly hear? Maybe its blocked.
Removing to create my bov noise? From what i read before if i replace with 5mm with no pill it will be louder.
Just wondering if in the photo can do i remove both or just the first one from manifold to the first "T"?
Yea, im running 14psi - both turbos
Execpt im fitting a new turbo intake this week as my secondary has a split causing Limp mode (just on secondary) - BOV sound was quiet still before the split
Split was caused by taking it off to do the knock sensor as its is in the most nasty place and couldn\'t get to it. wouldnt go back on nicely as its done a good 165K
It is possible to close over (plug) the secondary relief valve? If got a GFB response on 50/50 but its quiet (cant hear it at all!) and was wondering if removing that would make it louder
Also what size silicone line do i need for vac lines ect. Want to change original lines for silicone ones
Is heat proof paint / Calliper paint able to be used on engine bay hoses, or will it not stick - could ruff it up with sand paper.
Not looking for peoples opinions on painting parts and how silly it looks, just want to know if it will work
Cheers
David
Ive got 19InHg at idle. And 10psi but its not kicking in. Eg feels like a standard car. Its not pulling like an boost. Idle about 550rpm with a broken engine mount I\'ve just discovered