Jump to content
Please check your junk folder for registration emails ×

neodowd

General Member
  • Posts

    166
  • Joined

  • Last visited

Posts posted by neodowd

  1.  madmike']

    [quote name='neodowd said:

    yes put it in neutral at the lights just like a manual. I put my foot on the break whilst changing into gear from a stop start in my auto makes change smoother

    /quote]

    WTF??

    What don\'t you understand about what I said?

  2. I have an 02 forester xt aswell, I have had problems with mine for the last year or so with it occasionally surging and not boosting properly. I had no Cel come on so was a bit of a guessing game. The car did drive a bit better when I cleaned the maf so I started there. I replaced the maf a couple of weeks ago and happy to say it has fixed the problem it is driving like new again. Try cleaning the maf and if it helps it might be worth replacing cheers

  3. Hi guys

    I have a 2002 subaru forester xt automatic. It has a problem where it intermittently becomes sluggish, you can put your foot to the floor and it feels like there is no boost and then a few minutes later you put your foot down again and it goes like a cut cat. It happens no matter what the outside temp and changing gears does not effect anything and usually this happens when the car is hot. Like today in christchurch was 22 degrees and it was acting like two different cars one minute super fast next very slow. I have cleaned afm to no avail got no codes and was wondering could a bad front 02 sensor give you intermittent sluggishness without triggering a cel, sorry for the novel any help appreciated ta :)

  4. Yea thanks, I already read through that before posting my questions but nothing really answers what I want to know.

    And I also tried to unhook negative off battery to clear stored codes but the alarm goes off and I don't have key to turn off siren.

    Does anyone know how to unhook battery without activating alarm, I have tried with alarm off and ignition on and the siren still goes off :-(

  5. Hi guys

    got a few questions for all you knowledgeable people out there. I have a subaru forester stb 1999 which has been converted to manual from automatic.

    The cel light comes on intermittently for a few minutes a couple of times a day. The cars drives well with no noticeable problems, Now I checked the codes with just the black plugs and it came up with 5 codes correct me if I'm wrong but are the black plugs just stored codes not current ones? Then I plugged both green and black plugs and took it for a drive after a few minutes it came up with three codes. the codes are as follows

    Black plugs (stored codes???)

    12-starter switch

    22-knock sensor

    23-mass air flow sensor

    24-idle air control valve

    32-oxygen sensor

    Black&green plugs (current codes???)

    12-starter switch

    32-oxygen sensor

    51-park/neutral position swith AT (mine used to be an auto)

    Questions

    Is the black plug just stored codes and how is they are not cleared when both green and black are plugged in?

    Out of the three codes I got with both black and green plugs which one would most likely give you an intermittent cel which does

    not appear to effect car much?

    Any opinions or theories would be appreciated.

    Thanks :)

  6. Yea The cats get blocked up the older they get, so getting rid of the centre one will let it breathe again. I had all the cats removed from my gtb including the one on the front pipe primary turbo side. People do say if you remove the cat out of the front pipe you can cause the primary turbo to overspool, but I have seen no factual evidence on this. And I had no problems what so ever ;)

  7. Hi Guys

    Today I was driving about 30km/h and there was a clunk from my gearbox and the eco light started flashing on my dash. It would only drive in a high gear maybe 3rd gear and would reverse fine ( I found out via the net this is a fail safe mode). When I took off from a stop it was like trying to take off in 3rd gear. Well any way I turned the ignition off and then back on and the car is fine shifting normally in all gears. Is there a way to check codes from the tcu? and has anyone had anything similar happen with there car. Thanks

  • Who's Online   0 Members, 0 Anonymous, 193 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...