pedro
-
Posts
2,051 -
Joined
-
Last visited
-
Days Won
13
Content Type
Profiles
Forums
Events
Store
Posts posted by pedro
-
-
ok..if you need anything let me know ..
- 2
-
Hi Inked..what did Tony tell you?
-
new models are released towards the end of the year for tokyo motor show..so around august/september..
- 1
-
how it looks when i drive past the big shop windows
- 1
-
Because you are not in control of the vehicle..
-
Confimed purchase of two post clear floor hoist and compressor..Sweeeeeeet..
- 7
-
Quite a bit of slope on that corner ..car looks level but not..
Went and had a look on sat and can't say i am a fan of the long curcuit..
It takes away the white knuckle fun of of the back straight and sweeper..
Lots of nice cars there..
- 1
-
Clean,clean,clean..
No lint rags..
Did i say clean,,
- 1
-
On 9/11/2018 at 9:48 PM, Individualities said:
Good to know. Was always told by the certifier in my town you had to. Guess he's wrong lol
He was probably refering to old starlets on chopped and non captive springs..
- 1
-
Have bought 4 orders over the last few years..
Found out about them from oldschoolnz..
-
Another supplier is Rockauto.com usa..Probably the largest range for all makes and models.
Be aware that US models are different in some ways so pays to cross reference..
Rockauto prices are very low but freight from US is expensive so shop carefully..
-
how much was the freight from partsourq ?
-
-
Skid marks and holes in fences..someone has repairs this week..
Your car is going well Loren..
-
superceded parts..you order the old number and they supply with new number ..same part..
- 2
-
Try bleeding with the front of the car raised.best on a hill or steep driveway.
- 1
-
Clutch release bearing can be damaged during assembly if not careful.
-
15 hours ago, Leufkax said:
Front inner CV popped pulling out of my driveway. New complete driveshaft from Repco and about ten minutes, sorted.
those complete axle and cv assemblies are good value.. and no mess when fitting..
- 1
-
Got the keys for the new property yesterday so once we have a shed party the work on the coupe can start.
New twisted uppipe ( autobend ) and remade down pipe to mount turbo as close to level as possible.
Fit 850 sidefeeds and road tune before engine out and rebore etc..
Reassemble with new bits and then run in and dyno tune..
If that all happens before flatnats i will be happy
Still looking to buy a set of te37 16x7.5 0r 8.Prefer white..and a v4 coupe drivers seat ,condition can vary as could be used for parts.
- 2
-
looks like a v5 1999..
- 1
-
use genuine parts from subaru dealer..
-
nothing wrong with that result..
- 1
-
Direct from kinugawa or mamba on Ebay..Heaps of combo's and as long as you deal with factory direct you are ok..
Have a look and see what is out there..
- 1
-
Your logic is sound Inked..
Better the devil you can find when things go lopsided..
If the price is the same as importing ie $1100..Then go for it..
- 2
-
Who's Online 1 Member, 0 Anonymous, 175 Guests (See full list)
Clutch slipping
in General Vehicle Discussion
Posted
Sounds right..A little clutch slip will take the sudden shock load of the box..