toad

Thought I'd do it while it's just a shell on wheels. Clean it up a bit.

Hey, Has anyone Deloomed there engine bay? If so any chance of pictures. I've just started in my forester

Awesome will check in there. The dif is same ratio as gearbox. Only difference I can see is the rear halfshafts on the manual have the pins holding them in and the auto ones have no pins.

Hey, long story short I got a 1997 forester which I got as payment for fixing a car and it was auto but the previous owner had started a manual conversion using bits out of a bc5. He put peddle box in and that's all. I have the gearbox, diff, driveshaft, halfshafts, a complete rear subframe assembly hubs etc aswell, everything needed to do the manual conversion. My question is do I use the hubs, halfshafts and what else out of the rear subframe of the bc5 would I need or can I use some of the Forrester gear? I also have a complete front subframe with hubs etc as well. How much of that would I need for the front or can I use the Forrester gear. Not sure if the halfshafts are the same length and the trailing arms etc. Any help would be awesome. Thanks

Sweet thanks

Is it possible to put a electronic speedo drive bit in a gearbox that has the old speedo cable?

Awesome thanks. Will give him a call tomorrow.

That's algood, thanks. I think they should work, just thought I'd ask first lol.

Hey, I have a motor out of a 1997 sf5 forester turbo and a 1990 bc5 legacy turbo motor. Will the heads off the forester motor work with the closed deck block of the legacy? Also are there any differences in the Pistons in each motor or can I keep the legacy ones in there or put forester ones in the closed deck? Any help would be awesome. Thanks

gutted dude thats shit

too much money and no ideas lol

different lol

dont the knock sensors have to be torqued properly? as if they to tight they pick up every knock and if to loose pick up the vibration knock?

http://www.facebook.com/photo.php?fbid=495471253811018&set=a.320515747973237.82779.100000444440955&type=1&theater

will check tomorrow as not to sure

with my foot on the clutch we can still move the fork back and forward?

also ive been told that the flywheel should have a step on it where pressure plate lives? whats are the specs for flywheels

hey, i put a h/d clutch kit in car last week and a 2nd hand flywheel which i got machined as my flywheel grew legs and dissapeared for some reason. put it all back together and now the clutch flares. ive had the flywheel and clutch kit bench tested for pressure and it was fine. i never had the clutch cylinder open so havnt needed to bleed it. ive replaced heaps of subaru clutches at work and for some reason my own wont work (typical). any help would be appreciated as the motor has been out 3 times since the clutch was put in as different people had different ideas as to why its doing this. thanks ??? ??? ???

pm me ur number and i will txt u k

lol thats algood. whens a good time? i work 8-5

i can call round and have a look sometime if u want

where abouts are you

thats a nice and tidy subaru dude

im dwn in invers

how much? im keen