Two things get mixed up in these listings: the material and the coating.
"Cotton" here is almost always a fibreglass / basalt blanket - the fibre does the insulating, and 600 C is roughly where standard E-glass starts losing strength. True ceramic (alumina-silica) holds well past 1000 C, but it's abrasive and it really doesn't like being soaked and baked repeatedly.
The "alloy sealed" version is a foil laminate over the blanket, and that part is genuinely worth paying for. The usual failure mode of plain wrap isn't heat - it's oil or coolant soaking in, then baking into a crust that holds moisture against the pipe. Sealed still has stitch holes, so it's better, not waterproof.
Practical bits: overlap 50%, stainless ties every 100-150 mm (not the supplied wire twists, they saw through the wrap), and wrap the downpipe top-down so the overlaps shed water. Leave the first 25 mm at the flange bare so you can still get a socket on the nuts.
For a road car in a NZ winter, honestly: a ceramic coating plus the factory shield will outlive wrap. Wrap is for a car you pull apart every season, or where you actually need to keep heat in the pipe.
By
nz_wagon_diy ·