czar loc
-
Posts
231 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Everything posted by czar loc
-
LMAO !!! haha. Dont want to be a hater and all but that car is motherf*&*/#+ ugly. Deffently a car crime
-
Throttle positon sensor... what are they worth?
czar loc replied to Caleb 895/1000's topic in Electrical
i got one second hand once for $20. -
yea in theory but being that the 6s runs yellows and will be stock tune. is it a waste of time. i assuming i should stick to the yellows.
-
i got a set of these 550cc. about to do a bd5a single conversion with a 6s ecu. would putting these be a better option than yellows? any real benefits?
-
cheaked your fuse box.
-
right gap on plugs?possible?
-
id check coils first, could be spark plugs fuel pump ect
-
no one else could have said it better.
-
i second that
-
yea. there good. got one two years ago. payed $699. its not noticeably laggy at all.and you do lose spotlights but front bumper needs a fair bit of cutting to fit nicely. i luckily had a body kit lying around and fits mint round it.
-
that makes me sick. never thort someone could do such a thing....
-
yea bro i had take lift one on to a trailer by myself. only about 80kgs my guess
-
f*#k yea lol .
-
add octane booster?
-
Subaru v3 vs v3 STi heads... Any difference ?
czar loc replied to KING PIN's topic in Impreza, Crosstrek and XV
Valve shim -
Won't hurt it i guess.
-
thanks
-
just a quick question, will non turbo 1997 legacy square engine mounts fit a 1994 with round engine mounts? from my research thay do but will thay be strong enougth? cheers
-
had same problem, fuel pump was on way out, i would replace that and see bro
-
might be pump? pop the gas cap n get someone to turn the key, if you dont here a humming its dead.
-
Do you have to take the inlet manifold off to replace the knock sensor?
czar loc replied to a topic in Legacy & Outback
10mm and a 12mm from memory, pliers, small ratchet and a 20cm extension, and a attachment to get the bolt out on an angle( goes between the socket and ratchet) -
Do you have to take the inlet manifold off to replace the knock sensor?
czar loc replied to a topic in Legacy & Outback
no. just a tight space to get in to(need the right tools), take top mount off and a few water hoses, and is below throttle body on pasangers side of block -
??
-
dose this apply to all ej20's?? cheers
-
any specific tension this should be tightened too?
-
Who's Online 0 Members, 0 Anonymous, 97 Guests (See full list)
- There are no registered users currently online