what the thread size of the bango bolt for an ej20 turbo feed?

[dubbedup]

Im going to find the correct brass fitting so i can run a oil pressure and maybe a temp gauge out the factory feed since i am not currently using this to feed my turbo anymore, and just wanted to be 100% sure.

also would an oil temp gauge be better in the sump plug due to heat soak in the block/being near my turbo?

[PhatRS]

Sump is the ideal place for it, or you can use the blanking bung behind cyl 3 which is m18 x 1.5. Same as the std oil pressure fitting so you can use one of them and retap to suit your sender if you need.

[BLAZD]

im 99% sure its 12mm 1.5

[Guest vf20/21bg5]

or 12x 1.25

[WRXONP]

its a fairly course thread think its 12x1.5...i have one in the shed if im reminded tomorow i will measure it and check thread with my thread file

[Guest vf20/21bg5]

its 1.5 then ...i have a 1.5 and a 1.25 and they are soo different.....i know what threads i got on my tdo5h lol but am unsure for the vf turbo's unless i went out to the garage now and checked my old turbo, but i cant be arsed ;D...if you dont have a definate answer yet i can go check for you?

[WRXONP]

 PhatRS said:

Sump is the ideal place for it, or you can use the blanking bung behind cyl 3 which is m18 x 1.5. Same as the std oil pressure fitting so you can use one of them and retap to suit your sender if you need.

not talking bout the banjo anymore lol