TPS wiring

[94bg5]

Hey does anyone know if a 4wire bh5 gt tps can be wired as a 3wire to fit a BC gt loom and ecu?

Any help would be much appreciated.

Also same question again for the water temp sensor, BH sensor is 3wire, BC is 2wire

Thanks in advance, so close to being ready to drive.

[igkgunn]

 94bg5 said:

Hey does anyone know if a 4wire bh5 gt tps can be wired as a 3wire to fit a BC gt loom and ecu?

Any help would be much appreciated.

Also same question again for the water temp sensor, BH sensor is 3wire, BC is 2wire

Thanks in advance, so close to being ready to drive.

Pretty sure the 4th wire on them is a idle switch, so you should be able to use it without it if you want

[94bg5]

Sweet i found after reading heaps of electrical manuals for them that i can skip the extra wire.

1 part thats got me stuck though, the 6pin iacv, can it be wired to fit the 3pin plug or will it be a case of making an adaptor to fit the old throttle body? Would rather do a wiring job if possible