What bearings do I need?

[Decimate]

Hey guys,

I\'m after some ACL bearings for a rebuild, but the ACL site gives several options as below - I\'m wondering if anyones bought them for a gen 1 CDB before, and if they recall what part numbers they had? Options are below:

Rod bearing: is ours 48 or 52 journal?

Main bearings: we\'re #3 right?

And I guess it makes sense to do mains and rods instead of just rods at the same time? Not sure why it gives 2 x options for each

Cheers

0

[gotasuby]

the x on the end of part number means extra bearing clearance for higher performance cars

[Stoffa]

For 2.0 closed deck block you need 52mm big ends with #3 thrust(centre thrust) mains. get your crank measured first. i had a brand new crank and went with HX big ends and main cos im running much bigger clearances than factory

[Decimate]

Thanks fellas!