headlight lens

[B4 I was 250T]

anyone got any idea if these can be pulled off? Don\'t ask why lol

[lachlan]

yes . put it on the oven on like 60 degrees for like 5 minutes . softens the tar like glue . then screw driver some tabs/clips etc

prolly coulda gone in the dumb questions thread too

[B4 I was 250T]

Thanks Lachey, and to reattach the lens….??

[Marky]

Stick it back in the oven, mush it back on. Or bust out the silicone sealant

[B4 I was 250T]

Awesome, thanks heaps to you both ;D

[Marky]

Just be careful... Have seen it go wrong a couple times. The melting point of the glue isn\'t too far off the point where the plastic starts to deform

A hair dryer or heat gun will help with prying the lens out and don\'t touch the inside of the lens

Google will bring you a dozen DIY guides as the internet loves to reinvent the wheel a few times

[B4 I was 250T]

Thank you for the warning! Wanting to try (try being the operative word) to make angel eye headlights. Thanks Marky, you are the man!

[Lionbrown0]

Ha yes Marky is right about the deforming part found that out......... Just take your time

[lachlan]

the grey glue holding my v5 lights together was pretty soft when the lights were just above too hot to hold on to for a long time .

eg could pick them up and try pull on them then had to switch hand etc . much hotter and i woulda thought the glue was about to start running