Zero sports sequential controller settings

[Cloud]

I have a 1999 be5 rsk b4 manual. It has this controller installed. Was wondering where the best point in the rev range is best to change over to secondary? And also where to set it for changing back to primary? Car has only a gfb hybred BOV and after market muffler on the back. The controller is currently set at 4500 for change over and 3300

[ReubenH]

Depends how you drive it, and what issues you were having with VOD

For me i was always getting stuck in it wih my town driving, so bumped the crossover point up a few hundred RPM.

[Guest]

I have just installed a Zero sports sequential controller in my 98 Gtb and when i start the car with the controller on the car only runs for a few seconds before turning off. I have double checked all the wires to make sure they are properly connected but it still turns off. I can start the car and drive normally with the controller off but when i turn it on the car turns off. Any help would be greatly appreciated!!

[ReubenH]

Did you get the diagram the right way round.

Quadruple check it.

[Cloud]

I will just leave the settings as they are then, It was installed by last owner so was just wondering if it was right, Carry on