Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

Dual Side Heater Playing up


xlr8

Recommended Posts

Sorry if this has been covered before. In my BP5 the drivers side heater is acting up. Runs fine on cool, but as you ramp the temp up it stays fairly cool. The air gets redirected towards your feet etc. like it should, its just doesnt get a whole heap warmer. Once it gets above 30 degrees on the control it gets a little warmer, but nowhere near as much as the passenger side set at the same temp. Ideas?

Link to comment
Share on other sites

  • Admin

If it was a blocked filter or piping airflow would be limited not just colder.

Not sure if they have two separate heater coils to do left and right or just one, assuming two to provide the differing temps with airflow remaining the same. so you're best bet would be to look into trying to flush the coil/coils as they are probably quite blocked preventing coolant from passing through them. Hence no heat

Link to comment
Share on other sites

Had another play around today. It seems that the right side is about 5 degrees cooler than the left side - So if I set the left side to 25 Id have to set the right side to 30 to get the same temp air blowing out of them. Are there 2 separate temp sensors in the cabin or do both sides use the same sensor?

I dont think its a blocked heater coil because when it automatically changes from the face vents to the floor vents warm air starts coming out. The point at which it does that is set 5 degrees warmer that when it happens on the left side. I hope that makes sense.

Edited by xlr8
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recent Status Updates

    • MrSg9Sti04

      Afternoon team,
      im new to the group first time posting. Im hoping some body can help me get my launch control all dialled in on my link g4x. Ive had the computer and car all tuned from chris at prestige awesome knowlegable guy super happy with the results but now im wanting to get my launch/anti lag all dialled in. Ive been reading multiple different forums etc all with different conflicking information which has made me nervious with what do i listen to this or that if you get what i mean. Now ive started to make myself familiar with my PClink software etc the past few weeks and im eager to learn how to do minor setups or tweaks etc so im not relieing on my tuner so much and obviously saving myself abit hurt in the back pocket. 
      Now back to the question at hand.... Im wondering if theres and one who could please share there knowledge and wisdom with setting all my values, timing, fuel etc when i have launch control armed and engaged, or even a launch tune file they can possibly send me to load onto my tune. Ive figured out the setup of my digital inputs turning launch control on etc and its obvisously on its pre set factory settings. It engages but doesnt sound the greatest or as angry as it should i feel. Hence reaching out to you good buggers. 
       
      Cheers in advance for any info and help yous maybe able to give me.
       
      Cheers Shaun
      · 0 replies
    • Joker  »  gotasuby

      updated your DP's too : hope that's ok!
      · 0 replies
    • Joker  »  SAS

      Updated your DP's to reflect your business page  
      · 0 replies
    • Joker  »  Nachoooo

      Updated your Avatar : couldnt help myself  cheers!
      · 0 replies
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    40.9k
    Total Topics
    573.6k
    Total Posts


×
×
  • Create New...