Pappu1

I\'m with Kiwifozze on this one Possible knocking strut

saw the car at countdown in manukau while reading the mag..nice did u have the tap ya plates before? saw similar car with tap ya plates in aspiring ave manukau area...?

What is Gdb filter model then?

is the a360 airfilter for the GDA/B impreza bro? i looked at the ryco booklet in supercheap and didnt show the panel filters damm el cheepo book hahah

hahaha tru true lol and its not even my car do u work at bnt now /

Prob only in Silverline one easy way to find out. where wud be a better bet to get it at - repco or supercheap? could do a lunchtime trip lol removing a pod setup for a v7 that got pink stickered and putting to stock hence need a filter

have not checked price but u reakon repco or supercheap will have it for $10 for the v7 filters?

Custom setup will be the way to go

It\'s not hard to do for the right person to do

Wind up is cooler in a Ra somehow lol The number Of times I had been asked Abt windup and the roof scoop heheh

haha yea man..is good just a pain sometimes when have to start reaching over

+1

As above its perfectly fine The wind up windows may be the only difference u feel lol

Is it in English? May have a mic jack behind it ?

v7sti?

lean towards no as far as i know the ra didnt come with rear wiper perhaps a v2 with a roof scoop fitted? best to: whats the model code etc and compare?

will let him know abt the mesh hmm he is doing some vac hose mod and getting more boost from the setup already dunno what that is abt as have not seen under bonnet but he says its high teens( think he said was 18 or something lol) yea bg legacy...poor car gets a hiding

he is a cheapskate and is a bit of a diy guy lol he was even gona run the stock bov vent to atmo lol had to convince him otherwise hahaha

does bashing remove all the cat material lol wont the heat shields come in the way? wud it be better to somehow cut eh cat out and then weld a straight pipe in place or does that not work well?

whats the best way to decat a stock downpipe i assume will be same process for wrx as well at TT legacy? mate has a 96 gtb and wants to decat the stock downpipe - any how to be good

Get the one made for any v3-7 and they all fit straight on No need to muck around with the v8 and welding and all that Get a fmic Get a ebc Gt a tune These will give a better bang for bucks then headers I reakon B prepared to sound like a Honda once u go equal length Just FYI WhT other mods u have

that is the difficult bit ion using a new temp sensor..have seen some scalings for some sensors online in various forums but unsure how correct they are at least we know the stock one is scaled ok

Not a bad price If u hav use them and been ok with the job then yea should use again I suppose Is it the place in manukau I told u of?

Out a gauge and see what u getting to Also try this boost say 3rd gear to Abt 4000rpm and then let off and see if there is any difference in noise on bov What sorta bov is it?

Nice one bro!!