Hydraulic Handbrake Install

[wrxguy]

Anyone have any photos of installing and a setup hydraullic handbrake?

After some ideas on where folks have run their lines and how you have set it up etc.

Cheers

[funkytown]

#BLAZD

[wrxguy]

"HUH"?

[loner]

I\'ve done it... no photos though... it\'s pretty simple. run a line from the master cylinder through the firewall... I used the passenger side... run it along the

transmission tunnel to the handrake cylinder... then run a line continuing back across the trans tunnel, behind the drivers seat... there you will find a bung were

the original rear brake lines were (or still are... or maybe the fuel lines??? can\'t remember)... under there (under the car) put in a t-section then run to both rear wheels.

[loner]

 loner said:

I\'ve done it... no photos though... it\'s pretty simple. run a line from the master cylinder through the firewall... I used the passenger side... run it along the

transmission tunnel to the handrake cylinder... then run a line continuing back across the trans tunnel, behind the drivers seat... there you will find a bung were

the original rear brake lines were (or still are... or maybe the fuel lines??? can\'t remember)... under there (under the car) put in a t-section then run to both rear wheels.

Obviously you remove the original rear brake lines completely.

[wrxguy]

OK. Cheers mate. I just got back from sea this morning so now i can get back into building the project!

[loner]

 wrxguy said:

OK. Cheers mate. I just got back from sea this morning so now i can get back into building the project!

no problem... just remembered I ran the line through the prop valve first, then the handbrake cylinder... they were

right next to each other anyway.