need a wheel stud&nut/set hookup please? (not sure where this belongs)

[Doris]

Do we have a club sponsor? (or trade affiliated charitable club member

Like every other part on the Ace, OEM spec studs are near impossible to source (M12x1.25 -.-)

So the sensible option is 16 new wheel studs of the M12x1.5 variety but 16=$200 inc on my trade account at autostop, its down rightt terrifying!

So yeah, is there someone on here that can assist with a better option?

(nothing fancy, was going for a steel set from Nice Products)

Pretty pleeeease?

>blank studs would also be an option, I have a 12x1,25 die nut (if blanks actually exist?)

Thanks people

[DRFVDR]

M12x1.25 should be easy as to get as most toyotas run that size

[Doris]

I think its all the other dimensions that make it so obscure...

I\'m at my workbench right now, so I\'ll post them.

Length (overall) 35mm

Shank length (threaded) 20mm

hub side:

Flange O.D 22mm

Flange depth 4mm

Shank O.D (spline) 14.35mm (outer-most points)

Shank depth (spline) 6mm

Anything I\'ve neglected to measure, just ask.

But yeah this request is more centered on me baulking at the prospect of $10+gst for each single stud&nut.

[Doris]

Naturally though, im not above just going to pickapart and raiding a whole car of whatever I manage to find that will fit.

[Guest]

I have a friend that should be cheaper. Will pm dets later this morn.

[lachlan]

trojan sell them in sets of or half a set etc . and trailer spec ones are prolly similar in size to your ace . well trailer hubs are pretty runty compared to a car etc = ace sizes

[Doris]

Cheers Evowrx! Much appreciated.

Hmm I\'m gonna follow up on this Trojan lead, it sounds very plausible

[bobbyjimmy]

http://forums.nasioc.com/forums/showthread.php?t=885825

Biggest thread ever on wheel studs - standard and extended.