Wheel Alignment question?

[grim]

I have just had new tyres fitted and did the usual wheel alignment, ballance etc. I found out afterwards that they used the specs for a '07 car, not mine.

The settings used and the correct specs are below, does anyone know if the difference is important or not?

Actual Correct Spec

Front camber L-0.57 R-0.46 -0.127degrees

Caster L6.06 R6.24 5.920

Total toe front L0.2 R0.2 0.000

Rear camber L-1.45 R-1.15 -1.250

Total toe rear L0.6 R0.6 Total 1.2 0.000

[GC8E2DD]

You probably don't want the toe - but that is a tiny amount. Slight increase in castor all good - unless you have altered your suspension I don't think they can adjust that anyway. Half a degree more negative front camber - all good.

[funkytown]

the only thing i would change it the toe, get it straight front and rear if its a daily driver.

[KTM_GUY]

i'd leave the front toe where it is as they've increased the front camber and will compensate for the extra camber.. as for the rear toe i'd drop it slightly to about .3 or zero toe it, subbies like zero toe but with more camber it ok to have a little toe as it spreads the wear across the tyre rather then the edge.

ps : It also depends on if their alignment reads in 60 mins or 100 too... and if your spec measurements are also done to 60mins or 100 too.. that does make a difference.

[grim]

thanks