MTA approved mechanic that can do disc machining in christchurch.

[whatchain]

any1 know where i can use some mta vouchers to get my rotors skimmed in christchurch? im in the ilam region

[thorpy]

Autotech in Hazeldien Rd do disc machining , im sure they are MTA.

[slystiguy]

Don't use autotech. Had a bad experience with them a few years back. Would not trade again.

[whatchain]

lol i reed a review on google maps about their shop. someone said they were very bad... my rotors needs skimming and i want to use my mta vouchers to do this. does any1 know if armstong is mta approved or could i use those vouchers there?

[subieboy]

Just my humble opinion, but why bother skimming when new is similar in price???

[whatchain]

 subieboy']

Just my humble opinion, but why bother skimming when new is similar in price???

[quote name='subieboy said:

Just my humble opinion, but why bother skimming when new is similar in price???

i dont actually know how much it cost to get rotors skimmed. (>.<) thats why im asking, where could i get some cheap new rotors from then?

[newsuba]

Try BNT or Repco - their TRW's are very good and cheap ~$200 for a pr of 294mm fronts last time.

[Guest]

 newsuba said:

Try BNT or Repco - their TRW's are very good and cheap ~$200 for a pr of 294mm fronts last time.

OUCH...Ive got a retail of 76 each and I never sell anything for retail.

Machining is normally 40ish a pair any engineer can do it.

[newsuba]

My guestimate was waay out.

$139.38, three years ago.

;D