Topic: Car almost done! (Read 576 times)

dubbedup · « **Reply #45 on:** February 26, 2010, 10:11:58 am »

usually black sooty looking...altho you can give them a wee sand/scratch...

kingersman · « **Reply #46 on:** February 26, 2010, 10:19:32 am »

ok tried to do what you said josh man.
i couldnt see any spark on it(looking from drivers door)

dubbedup · « **Reply #47 on:** February 26, 2010, 10:31:28 am »

hmmm...i can only think of that 3 wire plug that goes to the crank/cam sensor.

kingersman · « **Reply #48 on:** February 26, 2010, 10:35:48 am »

there was a bit of soot on the plugs as well around the spark...
plugs are gone?

dubbedup · « **Reply #49 on:** February 26, 2010, 10:38:27 am »

gots some sand paper...

when checking plugs did you have then near an earthing point so the spark would jump?

kingersman · « **Reply #50 on:** February 26, 2010, 11:13:21 am »

ok got sand paper, suppose i sand in the gap?

yes i did and no spark from what i could see

kingersman · « **Reply #51 on:** February 27, 2010, 03:25:26 pm »

ok dave came around and had a look.
turns out cam and crank sensor were oily, so cleaned them up and now have spark but not enough spark ahaha so new spark plugs on pay day it is!

Author Topic: Car almost done! (Read 576 times)

dubbedup

Re: Car almost done!

kingersman

Re: Car almost done!

dubbedup

Re: Car almost done!

kingersman

Re: Car almost done!

dubbedup

Re: Car almost done!

kingersman

Re: Car almost done!

kingersman

Re: Car almost done!