Omsin

Recommendations for Handling

Recommended Posts

Just bought a 2011 WRX Sedan

 

Fitted some 18x9.5 Work Emotion Kiwami wheels last night and have just ordered:

-Blitz Coil overs with front camber plates

-Sti front and Cusco rear strut bar

-Whiteline front and rear sway bar kit

-Whiteline control arm brace

-Cusco pitch stop arm

-Whiteline Sub-frame/steering column/rear diff bushings

-Kartboy shortshifter with bushings

-Whiteline Raised front roll center ball joints with new tie rod ends

 

What would you guys recommend to help get the alignment to decent spec and improve handling?

 

Rear camber arms?

 

Toe arms for front or back?

 

Trailing arms?

 

 

In terms of reinforcement, I'm looking at a lower control arm brace that links both sides but so far haven't due to shipping cost

 

It's my daily driver, not a track car but I like having a good solid feel through corners. 

 

In terms of performance it has an upgraded larger top mount intercooler and intake with a tune for 98 gas, I have looked at a larger silicone turbo inlet and a full exhaust but can't justify the expense. Might just do a cat back (will I need to re-tune?) and call it a day as I'm ok with how it sounds now (the original exhaust is a little rusted however so theres an excuse to replace it :P )

 

Any ideas or experiences with what you guys have done that's made a good improvement?

 

I'll be looking at upgraded brake pads and rotors in the next few months too

 

P.s even a decent place to buy parts from, importing from the USA isn't my favorite choice

Edited by Omsin

Share this post


Link to post
Share on other sites

congrats, is that a facelift my11 model ?

my11 wrx and sti already got major suspension upgrades.

for a daily i'd leave it alone.

 

no mention of tyres.

first handling upgrade should be decent tyres, which will improve steering, handling, braking.

Edited by newsuba

Share this post


Link to post
Share on other sites

nice!! have you got the whiteline anti lift kit & Bump steer kit? that could be of benefit. besides that sounds like you have the basis covered! CR Kais have to be one of my favorite wheels cant wait to see pictures. 

 

As for brakes - Znoelli are awesome I have the DDS discs and have had no issues and run their sp500 pads

Share this post


Link to post
Share on other sites

All those bushes are a big help to power delivery.

Those roll centre kits are great too if you are super low. 35mm drop minimum if you don’t go lower than that the steering get light and handling goes crap. 

 

those toe arms are hard to get legal here now :(  

 

The down pipe and tune are best to do before the cat back as the down pipe increase noise a lot. 

  • Like 1

Share this post


Link to post
Share on other sites

Congrats on the car.

Thats a lot of suspension upgrades for a daily. I would start installing one or two at a time and then drive it for a while and then move to the next mod. You can easily make it too harsh for a daily if your not careful (I did this and it gets annoying after a while).

Both sway bars and blitz coilovers will make a huge difference alone.

 

I recommend getting a downpipe and get the tune touched up like @Gripless said.

 

Brake pads - Call these guys and they will give you good advice https://braketechnz.com/

Share this post


Link to post
Share on other sites

Yes - My11 Facelift - Premium (leather + sunroof)

 

Tyres are decent - definitely something I won't cheap out on again (makes car useless the moment you try go a little bit fast)

 

The raised lower ball joint / tie rod ends are supposed to help with bump steer but doing it more as the factory ones are starting to disintegrate and I'm preempting issues with the drop when I put the coil overs in. Will look at getting the Whiteline bump stop bushing kit once I've got everything installed and see how the car drives.

 

Work Kiwami wheels were second hand but like new, actually the second pair I've had and on my second Subaru haha (V11 STI with chrome blue Kiwami).

 

I'm guessing I might have to roll my guards, any places you guys would recommend?

 

 

Will upload pics if I get home before dark

 

For now here's a teaser of the rear strut bar install:

 

IMG-2325.jpg IMG-2327.jpg IMG-2328.jpg

Edited by Omsin

Share this post


Link to post
Share on other sites
1 hour ago, Andy_Mac said:

Don't suppose they're matte black Kiwami’s?

Bronze, was thinking of matte black to go with the pearl white but haven’t seen any others in the 5x100 stud pattern for sale 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.