Saturday, Well, engine came back out! Fixed the misaligned clutch. Put the oil drain on, with heat shielding. Deleted the GDB clutch bleed setup in favour of single braided line. Got that around the wrong way. Fixed that. Engine in, wastegates off to check spring pressures. Now both have 7psi springs. Flumbled around trying to figure out how to get it all to fit in there. Turns out, turbo on first, then engine in, then downpipe, then wastegate dump pipe on wastegate, then wastegates in place. She's a little tooooight Also fiddled with fuel lines. Plumbed the -8 AN lines to the stock body for the time being. Then today! Get under the car to install exhaust manifold on engine. Promptly get it half on, drop it on my face, break my nose. Mint. Hospital check because recently had surgery on my nose and would rather sort that now lol. Reattempt getting manifold on without breaking nose again, am successful. Yuss. Replace the fittings in the wastegates, because old and cruddy. Cut heat shielding to size for boost lines. Run vac lines for wastegates. #goodenuff Sent from my SM-G960F using Tapatalk
I am having the same issue with my 2008 Tribeca :(. I would like to try to fix it at home as I can only raise the car up 10" with my 4 DIY rams, not enough room or clearance to remove the Valve Body I think.
Any ideas on what to test for now?
Injectors... Any way to check if they're happy without whipping them off and flow testing?
Do the above results prove the AFM is ok, or is it worth getting my hand on another one?