Jump to content
Please check your junk folder for registration emails ×
  • Current Donation Goals

    • Raised $0.00

What have you done to your car today?


Guest keltik

Recommended Posts

Switched to closed loop boost control figured the open loop table was close enough find out how it drives tomorrow. Swore lots and lots at clutch switch and decided to leave it till a weekend so i can pull seat out and slide under dash a little more comfortably.

May put on hoist tomorrow to do mani exhaust leaks if cbf but doubt that very much.

Oh and put on lower sti spoiler on the weekend.

Link to comment
Share on other sites

Got my 89 brumby running reliable on an auxiliary fuel tank, pretty much confirms my fuel pick up is blocked in the tank, not sure how I am going to fix it to be honest, no real ports in the tank, one very small one on the opposite side to the pickups for the sender unit, maybe tank out and replacement tank or just run a fuel tank in the bed

Link to comment
Share on other sites

 ballsrburning said:
Began stripping the bay again, changing the breather tank and the water reservoir is going, hate the factory one I'm using. Got to change fuelling system to make it legal too for new cert.

Now I have space to mini tub the front wheel arches.

What are you changing on the fuel set up?

Link to comment
Share on other sites

  • Admin
 DRFVDR said:
Got my 89 brumby running reliable on an auxiliary fuel tank, pretty much confirms my fuel pick up is blocked in the tank, not sure how I am going to fix it to be honest, no real ports in the tank, one very small one on the opposite side to the pickups for the sender unit, maybe tank out and replacement tank or just run a fuel tank in the bed

Cut'n'shut job?

Link to comment
Share on other sites

 ADIKT said:
What are you changing on the fuel set up?

I have the ethanol sensor in the cabin with two fittings on it, and I'm sure I read you can't have any fittings for the fuel line in the cabin has to just pass through there. Going to mount it on the fire wall in the engine bay and move the fuel reg too.

Link to comment
Share on other sites

Decided to change the bov location on the car and change to Gfb one. Finished redesigning the fuel lines and relocated the sensor and fuel reg, just got to extend the wiring.

Waiting on the combined water and catch can to be fabricated.

Link to comment
Share on other sites

Got the car back from the paint shop yesterday. Front, bumper, bonnet and roof are now all chip free. Although the finish is OK now, I had to take it back after I first got it last week. So don't make the mistake I did and get a Grabone deal for Onshow Kustoms. Ray is a nice enough guy, but seems to lack attention to detail. I'll post some pics once I get some wax over the new paint.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...